Filter
Top Products
Model H6310 Jump Starter/Compressor-8-
Hazard Lights
In the event of an emergency, the hazard
lights help notify oncoming vehicles of
your presence. This is especially important
at night when you are working on the side
of a road with busy traffic.
To use the hazard lights:
1. Turn the main power switch ON.
2. Press the green "Showing" button.
Flashlight
A built-in flashlight is included on the
Model H6310 to help you see when you
are jump starting a battery or filling a tire.
To use the built-in flashlight:
1. Turn the main power switch ON.
2. Press the red "Lighting" button.
DC Output Sockets
Four sockets have been included to power
DC appliances that use 3V, 6V, 9V, or 12V
power.
For 3V, 6V, and 9V appliances:
Use the power adapter that came with the
appliance or purchase a universal adapter
and plug into the corresponding socket.
For 12V appliances:
Use the included adapter and plug into
the large socket on the back of the Model
H6310. This socket and plug are also
universal with common cigarette lighter
sockets or adapters that are found in most
automobiles.
Securing Strap
The securing strap is included to hang
the Model H6310 from the hood of a car.
Hanging the Model H6310 will keep it out
of the way of moving parts like drive belts
and fans.
To use the securing strap:
1. Make sure the strap is fed through the
slide buckle and the slide buckle is
halfway up the strap.
2. Wrap the end of the strap (the end
WITHOUT the hook on it) around the
handle of the Model H6310.
3. Feed the strap end through the slide
buckle in the opposite direction.
4. Make sure the slide buckle will hold by
lifting the Model H6310 approximately
1" off the ground. If it doesn't hold, you
have the strap buckled wrong.
5. Hang the Model H6310 from the car
hood and adjust the strap as neces-
sary.
Storage
The Model H6310 should be stored with
the main power switch turned OFF.