Filter
Top Products
H7664 2-in-1 Combination Nailer/Stapler
-12-
SECTION 4: OPERATIONS
Loading
Figure 3. Catch lever engaged and
magazine pusher retracted.
When replacing brads or staples in your
Model H7664, follow these guidelines:
Gauge: 18
Brad Length:
5
⁄8"-2"
Staple Length:
5
⁄8"-1
5
⁄8" (crown
1
⁄4")
Capacity: 100
To load your nailer/stapler:
1. DISCONNECT NAILER/STAPLER
FROM THE AIR SUPPLY!
2. Grip the nailer/stapler firmly, unlatch
the catch lever (Figure 3), and pull the
magazine pusher back completely.
Figure 4. Loading nails into magazine.
3. Insert a strip of brads or staples, point-
ed-end down, into the magazine as
shown in Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate the
nailer/stapler.
Before you operate your nailer/stapler,
place two to three drops of the included
oil into the quick connect fitting where the
nailer/stapler connects to the air supply.
To operate your nailer/stapler:
1. Connect the air supply to the quick
connect fitting.
4. Slide the staples or brads all the way
down to the nose of the nailer/stapler.
5. Push the magazine toward the nose of
the nailer/stapler until the catch lever
locks.
6. Reload the nailer when the magazine
sight window (Figure 4) shows the nail
or staple level is low. The sight window
shows up to approximately 50 nails or
staples loaded.
Catch Lever
Pusher
Pusher
Sight Window
Magazine