Filter
Top Products
H7677 18 Gauge Stapler Kit
-10-
SECTION 4: OPERATIONS
Loading
Figure 3. Latching pusher in groove.
When replacing staples in your Model
H7677, follow these guidelines:
Gauge: 18
Length:
1
⁄2
"
–1"
Capacity: 100
Crown:
1
⁄4
"
To load your stapler:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
2. Grip the stapler firmly, and pull the
magazine pusher back until it latches
in the groove as shown in Figure 3.
Figure 4. Loading staples into magazine.
3. Insert a stick of staples, pointed-end
down, into the magazine as shown in
Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate
the stapler.
Before you operate your stapler, place two
to three drops of the included pneumatic
tool oil into the quick connect fitting where
the stapler connects to the air supply. Fire
the EMPTY stapler 3-4 times before begin-
ning, so oil does not come out onto the
project during regular operation.
To operate your stapler:
1. Connect the air supply to the quick
connect fitting.
2. To test for proper staple penetration,
hold the stapler perpendicular to the
surface of a piece of clean scrap wood
that is thick enough for the length of
staples you have loaded.
4. Slide the staples all the way down to
the nose of the stapler.
5. Release the magazine pusher by pull-
ing back and up. Gently slide the push-
er forward; do not let the pusher snap
against the staple stick.
Pusher
Groove