Filter
Top Products
H7677 18 Gauge Stapler Kit
-14-
SECTION 5: MAINTENANCE
Cleaning
Use a good solvent to clean the nose
assembly of the stapler. Always be sure
that the stapler is dry before using it
again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
stapler; this may result in leaks and dam-
age to the stapler and the air couplings.
Lubricating
Special oil has been included with your
new Grizzly stapler to help maintain its
useful life. Place two to three drops of oil
in the stapler air inlet (as shown in Figure
9) before every use, or after 2 hours of
continuous use.
Figure 9. Lubricating stapler via air inlet.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
Wipe off any excess oil near the stapler
exhaust to avoid dust build-up. When the
oil that was included with the stapler has
been completely used, replace with Grizzly
Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication
of your stapler will not be necessary.
Just make sure there is always oil in the
lubricator.