Filter
Top Products
H7945/H7946/H7995 26° Angle Nailer
-9-
Unloading Nails
To remove unused nails:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Point the nailer away from you and all
bystanders.
3. Slide the pusher to the rear of the mag-
azine and latch it into the lock notch.
4. Move the nails to the rear of the maga-
zine and remove them by hand.
Rotating the Exhaust
Cover
The exhaust cover rotates as needed to
direct the exhaust away from you.
To rotate the exhaust cover:
1. Use the 4mm hex wrench to loosen the
exhaust cover cap screw as shown in
Figure 6.
Figure 6. Loosening the exhaust cap
screw.
2. Rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3. Tighten the exhaust cover cap screw.
Exhaust
Cap Screw