Filter
Top Products
H7949/H7950/H7951 Nailer
-8-
OPERATIONS
Model H7949/H7950
Loading Nails
Use nails meeting the specifications listed
for your nailer on Page 4 of this manual.
To load nails in your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
Point the nailer away from you and
others when connecting the air supply.
The nailer can cycle and discharge a
nail when the air supply is connected.
Ignoring this warning may result in
serious personal injury.
2. Pull the magazine open from the cover
tab as shown in Figure 3.
Figure 3. Opening the magazine: Model
H7949/H7950.
Magazine
Cover Tab
3. Press the adjusting pin inside the
magazine and slide the plate up or
down until the plate position matches
the nail length as shown in Figure 4.
Note: The plate must be set at the
proper height or the nails will not feed
smoothly into firing position.
Figure 4. Positioning the magazine plate.
Adjusting
Pin
Magazine
Plate
4. Place the nail coil into the magazine
and uncoil enough nails to reach the
driving hole as shown in Figure 5.
Figure 5. Loading nails in the magazine.
Driving
Hole
Nail Length
Marks