Grizzly H8117 Paint Sprayer User Manual


 
Model H8115/H8117 Spray Gun-12-
7. Adjust the fluid control knob to start
with a low volume of material and keep
the atomization as low as possible. Use
a combination of fluid control, inlet air
pressure, air flow control and stroke
speed to achieve the results you want.
Spray so the material wets out nicely
without running or sagging.
8. Use the pattern control knob to adjust
the spray fan to your desired pattern.
9. Keep the gun tip perpendicular and
parallel to the work surface as you
spray from a distance of 152-203mm
(6-8") as shown in Figure ??. Keep
your wrist firm while spraying; bend-
ing your wrist will cause the gun to arc
across the surface and distribute the
material unevenly, possibly creating
sags, drips or dry spots.
11. Maintain an even speed when spray-
ing.
12. Overlap each stroke by 50%. This will
ensure even coverage as shown in
Figure 6. Less than 50% as shown
in the figure to the right may lead to
missed spots or streaky results.




Figure 6. Overlap technique.
13. Spray stroke should be consistently
even with parallel edges. If it doesn't
please refer to Troubleshooting on
Page 17.
14. To orient the H8115 spray gun down-
ward or upward, loosen the nut that
secures the cup to the gun, adjust the
gun angle and tighten the nut.
No
Yes
HEALTH & CONTAMINATION
HAZARD! Dispose of paint waste
in a responsible manner! Follow
manufacturer's recommendations
and local laws regarding disposal.
Failure to comply will result in con-
tamination and possibly large fines
and penalties.
10. Begin spraying 2-3 inches before the
work. Continue the motion for a few
inches past the work until you are
ready for the return stroke.
NOTICE
Tipping the Model H8117 spray gun
may cause material to spill out of
the cup. Always hold the spray gun
perpendicular to the ground to avoid
potential spills and gravity feed prob-
lems.