Filter
Top Products
Model H8214 Air Body Saw-4-
OPERATIONS
Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
3. Insert the blade fully into the blade
arbor.
4. Re-tighten the set screws. Verify that
the blade is secure and will not pull
out.
Note: Tighten both set screws with
even pressure against the blade or the
blade may come loose.
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.
Figure 2. Tightening the set screws.
Support Brace
To install a blade:
1. DISCONNECT THE SAW FROM THE
AIR SUPPLY!
2. Use the 3mm hex wrench to loosen the
blade set screws located on both sides
of the blade arbor (Figure 2).
To adjust the support brace:
1. DISCONNECT THE SAW FROM THE
AIR SUPPLY!
2. Use the 1.5mm hex wrench to loosen
the set screw located on the back of the
safety set (Figure 2).
3. Adjust the support brace to the desired
depth.
Note: Make sure that the brace is not
over-extended or else it will not be able
to be secured with the set screw and
may come loose.
4. Re-tighten the set screw. Verify that the
support brace will not pull out.
Blade Set Screws
Blade Arbor
Brace Set Screw