Filter
Top Products
-5-Model H8217
3
⁄8" Reversible Angle Drill 1500 RPM
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 5. Installed filter lubricator
regulator.
ACCIDENTAL
START HAZARD!
Disconnect before
service or tool
changes.
AIR PRESSURE
HAZARD!
Never exceed 120
PSI.
LUNG/EAR
INJURY HAZARD!
Wear protective
equipment when
using this tool.
EYE INJURY
HAZARD!
Wear protective
equipment when
using this tool.
4. Using the trigger to control RPM, ease
the working end of the bit against the
workpiece with a light, but steady, pres-
sure.
5. Reverse the drill direction by pushing
the reverse valve into the body, then
rotate to lock into position (Figure 3).
To avoid accidental starting,
disconnect the drill from the air
supply when it is not in use.
Daily Maintenance
Drop 2-6 drops of air tool oil directly into
the air fitting before using the drill. In
addition, drip 2-6 drops of oil directly into
the ball oiler by depressing the oil ball
located in the angle housing, shown in
Figure 4.
For improved lubrication to extend the life
span of your drill, we recommend using an
in-line filter, lubricator, and regulator, as
shown in Figure 5.
These procedures should be done after
each use:
• Wipe the motor housing and tool bits
with a dry cloth, or blow off the dust and
debris with compressed air.
• Check for damage to tooling, hoses,
housing or other accessories.
• Relubricate with 2-6 drops of oil into the
air inlet fitting before storage.
Ball Oiler
Figure 4. Ball oiler location.
Reverse Valve
Figure 3. Location of reverse valve.