Filter
Top Products
-7-Model H8226 5 Gallon Automatic Mixing Paint Tank
The pressure regulator on the paint tank
controls the amount of pressure applied to
the paint in the paint tank. It also controls
the pressure of paint delivered to the spray
gun.
The following are operating guidelines for
internal and external spray guns:
Internal Mix Guns: Use higher tank
pressures up to the full amount of air
pressure being delivered to the spray gun.
However, do not exceed 45 PSI at the
spray gun or in the paint tank.
External Mix Guns: Use lower tank
pressures—approximately 12 PSI for most
external mix guns. Start with the tank at
"zero" pressure and increase pressure
gradually until the correct spray pattern is
achieved.
Tank Regulator
Do not exceed the 50 PSI maximum
operating pressure on your paint tank.
Exceeding the maximum pressure
may cause the tank to explode,
causing serious personal injury.
This pressure tank is not designed for
use with highly abrasive, corrosive,
or rust inducing materials. If such
materials are used, frequently and
thoroughly clean all components to
reduce the need to replace parts.
EXPLOSION HAZARD! DO NOT
smoke or have any source of flame
or spark near spraying. Vapors will
explode if ignited.
RESPIRATORY HAZARD! Always use
a NIOSH approved respirator when
using spray equipment. Failure to
protect your lungs can lead to respi-
ratory illness and nervous system
damage. Spraying some paints and
varnishes may require a supplied air
respirator system.
TOXIC FUMES! Always use an
approved spray booth or well ven-
tilated area when spraying. NEVER
spray in a confined space where
toxic fumes and flammable vapors
can accumulate to deadly levels.