Grizzly H8231 Nail Gun User Manual


 
H8230/H8231 15° Roofing Nailer
-9-
The nailer is designed to fire one nail at a
time, or one after another, using the safety
nose mechanism—this is known as "bump
fire."
To operate your nailer in single fire
mode:
1. Depress the safety nose mechanism
against the workpiece.
2. Pull the trigger, then release the trigger
after the nail is driven.
To operate your nailer in bump fire
mode:
1. Pull the trigger and hold it back.
2. Press the safety nose mechanism
against your workpiece to fire a nail.
You can continue holding the trigger
back and firing the nailer in this manner
without releasing the trigger.
Single/Bump Fire
Operation
The Model H8230/H8231 features a depth
adjustment knob for controlling nail pen-
etration depth (Figures 8 & 9).
Adjusting Depth
Figure 8. H8230 depth adjustment knob.
The adjustment knob controls nail penetra-
tion by changing where the nose mecha-
nism stops when depressed. Moving the
nose mechanism out or extending it away
from the nailer decreases nail penetration
depth.
Determining the correct nail penetration
depth requires trial-and-error and may
change depending on the type of material
you are nailing.
Depth Adjustment Knob
Figure 9. H8231 depth adjustment knob.
Depth Adjustment Knob
Take care to lift the nailer from the
workpiece each time you fire a nail
when bump firing, or the nailer may
bounce acriss the workpiece and rap-
idly fire nails.