Filter
Top Products
H8230/H8231 15° Roofing Nailer
-7-
OPERATIONS
Loading
When replacing nails in your Model
H8230/H8231, follow these guidelines:
Nail Type: Flat Wire Welded Coil 15°
Roofing Nail
Length: H8230
3
⁄4"–1
3
⁄4"
H8231 1
3
⁄4"–2
3
⁄4"
Capacity: H8230 120 Nails
H8231 225–300 Nails
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Squeeze the latch shown in Figure 3,
then open the feeder cover and maga-
zine, as shown in Figure 4.
3. Pull up and rotate the adjusting plate,
shown in Figure 5, to match the maga-
zine mark with the nail length to be
installed. (Rotating the adjusting plate
locks or unlocks its position.)
Figure 4. Feeder cover & magazine open.
5. Close the magazine cover, then close
the drive hole and feeder cover and
latch it closed.
Figure 3. Feeder cover latch.
Latch
Figure 5. Adjusting plate.
Figure 6. Loading nails in the magazine.
Feeder Pawls
4. Place the nails over the adjusting plate
post, and put the first nail into the
feeder pawls as shown in Figure 6.