Filter
Top Products
Model H8233 3-Piece Framing/Brad Nailer & Stapler Kit
-9-
OPERATIONS
Loading
Framing Nailer
Nail Size ......................
1
⁄8" Shank Diameter
Nail Strip Angle ...............34º Clipped Head
Length..............................................2"–3
1
⁄2"
Magazine Capacity ........................60 Nails
To load your framing nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Grip the nailer firmly and point the nose
down, then pull the magazine pusher
back until the catch lever engages, as
shown in Figure 3.
3. Insert a strip or two of nails, pointed-
end down, into the magazine as shown
in Figure 4.
Figure 3. Sliding magazine pusher back
and engaging catch lever.
Pusher
4. Tilt the nailer to slide the nails all the
way down to the nose.
5. With one hand on the magazine pusher
for control, release the magazine catch
and slowly allow the pusher to press
against the nails.
Brad Nailer
Nail Size ..................................... 18 Gauge
Nail Length ...........................................1
1
⁄4"
Magazine Capacity ......................100 Nails
To load your brad nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Press the magazine latch, as shown in
Figure 5, and pull the magazine cover
back.
Figure 4. Loading nails into the magazine.
Figure 5. Pressing the magazine latch.
Magazine Latch