Grizzly H8259 Lathe User Manual


 


Figure 23
      

Spindle Turning
Workpiece
Workpiece
Center
Pencil Lines
Marked Diagonally
Across Corners
Figure 24.

Figure 23.

To set up a spindle turning operation:
1.    


Figure 24

1/4"
Figure 25.
2. 
       


3. 



4. 

5.         


Figure 25
6.       

7. 



8. 


Do not press the workpiece too firmly with
the tailstock or the bearings will bind and
overheat. Likewise, do not leave it too loose
or the workpiece will spin off the lathe. Use
good judgement. Serious personal injury
could result if care is not taken.