Grizzly H8259 Lathe User Manual


  Open as PDF
of 36
 


NOTICE: Only use tap screws or wood screws
with non-tapered heads (Figure 28) to attach the
faceplate to the workpiece. Do NOT use drywall
screws or screws with tapered heads because
these can split the faceplate, or the screws may
snap off during operation.
Figure 29.



2.        

3. 


4.      
      
       



To mount your workpiece to a backing block:
1.     Figure 29 
         

Figure 28

       
  Figure 30     

Sanding /Finishing
Figure 30. 



Sandpaper
Workpiece
Wrapping the sandpa-
per completely around
the workpiece will pull
your hands into the mov-
ing workpiece and may
cause injury. Never wrap
sandpaper completely
around the workpiece!
 previous next