Filter
Top Products
H3142 Pneumatic Palm Hammer Kit-6-
Nail Drivers
The Model H3142 Pneumatic Palm
Hammer Kit includes 2 regular nail drivers
(Figure 2) and 2 finish nail drivers (Figure
3). Three of the nail drivers have a small
magnet at the end to keep nails aligned.
Figure 2. Regular nail drivers.
Figure 3. Finish nail drivers.
Figure 4. Driver adapter.
Hand Strap Bag
The Model H3142 Pneumatic Palm
Hammer Kit includes a hand strap bag to
ease carrying and operation. Figure 1
shows the hand strap bag attached to the
palm hammer.
Figure 1. Hand strap bag on palm hammer.
To use the hand strap bag:
1. Install the hand strap bag on the palm
hammer and make sure each snap but-
ton is secure.
2. Place your fingers through the large
strap and place your thumb through one
of the small straps on the side, depend-
ing on which hand you prefer to use.
The nail drivers attach to the palm hammer
with the driver adapter shown in Figure 4.
To use a nail driver:
1. With the air NOT connected to the palm
hammer, install the desired nail driver
tool as per the “Changing Tools”
instructions on page 5 of this manual,
then connect the palm hammer to the
air compressor.
2. Position the nail where you want to
drive it.
3. Place the nail driver over the nail and
start the nail with a light bump or tap of
the palm hammer. This action should
only make the hammer actuate once.
4. Making sure the nail is started deep
enough to keep its position, firmly press
the palm hammer into the nail and hold
it until the nail is completely driven into
the surface.