Filter
Top Products
H3142 Pneumatic Palm Hammer Kit -7-
Hammer Head Tools
The Model H3142 Pneumatic Palm
Hammer Kit includes a steel-faced ham-
mer head (Figure 5) and a soft-faced ham-
mer head (Figure 6).
Figure 5. Steel-faced hammer head.
Figure 6. Soft-faced hammer head.
Chisel Tool
The Model H3142 Pneumatic Palm
Hammer Kit includes a chisel tool as
shown in Figure 7.
Figure 7. Chisel tool.
To use the hammer head tools:
1. With the air NOT connected to the palm
hammer, install the desired hammer
head tool as per the “Changing Tools”
instructions on page 5 of this manual,
then connect the palm hammer to the
air compressor.
2. Tap the hammer head against the
object for a single blow.
3. Press and hold the hammer head
against the object for multiple blows.
To use the chisel tool:
1. With the air NOT connected to the palm
hammer, install the chisel tool as per
the “Changing Tools” instructions on
page 5 of this manual.
2. Before tightening, rotate chisel so blade
is parallel to your work surface while the
palm hammer is held at the intended
angle of operation.
3. Tighten the jam nut on the chisel
threads into the base of the palm ham-
mer to keep the chisel secured in its
determined position.
4. Connect the palm hammer to the air
compressor.
5. Press the chisel against the workpiece
to make it actuate.