Filter
Top Products
12.
Note: A limit switch senses the electrical
resistance between the blade ends. If there
is an adequate amount of welded material,
the limit switch will not allow the weld button
to activate the operation again.
13.
14.
15.
Before welding a blade back together to per-
form an internal cut, insulate the entire blade
from the metal surfaces of the bandsaw to
ensure a good flow of current through the
blade.
Correct
Not Correct
Not Correct
Correct
Not Correct
Figure 17.
Blade Preparation
Welding
Page 7
Hot sparks from the blade welding opera-
tion could be thrown in all directions and
cause burns or fire.
When using the blade welder, always keep
the spark deflector over the clamps and
protect yourself from the flying sparks.
Have fire extinguishing equipment readily
available.
DO NOT weld near flammables.
NOTICE
For good metal-to-metal contact between
the welding clamps and the blade, make
sure the blades and the clamps are free
from any debris, coatings, or flash before
and after each use of the welding station.
16.
Figure 17