Filter
Top Products
-2-
Model T25448/T25449 (Mfg. Since 8/13)
Installation
1. Place the switch box in a dry, protected loca-
tion within reach of the power receptacle and
the dust collector power cord.
2. Plug the switch box into the proper power
receptacle (see Figures 2–3).
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
Figure 2. NEMA 5-15 plug and receptacle for
Model T25448.
For T25448
3. Perform the following Programming Switch
Box procedure to make sure the remote con-
troller will operate the switch box.
4. Make sure the dust collector ON/OFF switch
is turned OFF, then plug the dust collector
into the switch box.
Grounding Prong
Current Carrying Prongs
6-20 PLUG
GROUNDED
6-20 RECEPTACLE
Figure 3. NEMA 6-20 plug and receptacle for
Model T25449.
For T25449
Programming Switch Box
You can program one switch box to operate with
several remote controllers and one remote con-
troller to operate several switch boxes. The steps
to accomplish any combination of these options
are the same.
Before beginning, read through the entire pro-
cedure to understand the required timing of the
steps.
To program the switch box:
1. Make sure the dust collector is NOT con-
nected to the switch box.
2. Make sure the red receiving light on the
switch box is illuminated (see Figure 4).
— If the red receiving light is not illuminated,
the switch box is not receiving power.
Resolve this issue before continuing.
3. Press and release the black programming
button once—you will hear three beeps and
the red receiving light will flash three times.
The switch is now in programming mode.
Note: If you do not perform the next step
within approximately five seconds after the
three beeps, you will hear one more beep
and the switch box will leave programming
mode. In this case, you will have to start
Step 3 again.
Figure 4. Programming controls on rear of
switch box.
Programming
Button
Red Receiving
Light