Filter
Top Products
Model T25448/T25449 (Mfg. Since 8/13)
-3-
4. Press either button on the remote controller
(see Figure 5)—you will hear three beeps
and the red receiving light on the switch box
will flash three times.
Figure 5. Remote controller buttons.
ON Button
OFF Button
Sliding
Cover
5. Wait approximately five seconds and you will
hear another beep—the switch box is now
programmed to work with this remote control-
ler.
4. Press the remote controller OFF button once
to turn the dust collector OFF. The green
power light on the switch box will turn OFF.
Figure 6. Green power light on switch box.
Operation
1. Make sure the switch box is properly installed
and correctly programmed with the remote
controller.
2. Turn the dust collector ON/OFF switch to ON.
3. Press the remote controller ON button once
to turn the dust collector ON. The green
power light on the switch box will also illumi-
nate (see Figure 6).
Un-programming Switch Box
If necessary, the switch box can be un-pro-
grammed so that it will not operate with any
remote controller. In such case, you will have
to re-program the switch box to operate with a
remote controller.
To un-program the switch box:
1. Press and hold the black programming but-
ton on the switch box for approximately five
seconds—you will hear one long beep and
the red receiving light will flash once.
2. The switch box is now un-programmed.
Green
Power
Light