Filter
Top Products
-26- G1023Z Series Heavy-Duty 10'' Table Saw
Miter Gauge
The miter gauge for the Model G1023Z Series
has two setscrews in the miter bar which can be
set to remove any loose movement between the
miter bar and the T-slot.
To adjust the miter gauge:
1. Loosen or tighten the two miter bar
setscrews (
Figure 23
) until the miter gauge
slides freely in the slot, but has no loose
movement.
2. Loosen the lock knob on the miter gauge and
place a square against the face of the miter
body and the miter bar.
3. Adjust the miter body until there is no space
between the square and the miter bar.
4. Tighten the lock knob.
5. With the stop link (
Figure 23
) in the up posi-
tion, loosen the jam nut and adjust the stop
screw until it is seated against the stop link.
6. Loosen the setscrew on the left front side of
the miter bar, adjust the pointer to 90˚ and
retighten the setscrew.
7. To adjust to 45˚, follow Steps 1-6 while using
an adjustable square.
8. After rotating the miter body from 45˚ to 90˚
and back a few times, double check your
adjustments at both angles to ensure that
you have accurately set your miter gauge.
Figure 23. Miter gauge adjustment points.
Stop Link
Jam Nut
Setscrew
Stop Screw