Harbor Freight Tools 36572 Grinder User Manual


  Open as PDF
of 10
 
SKU 36572 For technical questions, please call 1-800-444-3353 PAGE 6
2. Prior to use, the Die Grinder requires the attachment of a quick connector (not
included) into its Air Inlet (1). To do so, wrap approximately 3” of pipe thread
sealer tape (not included) around the male threads of a quick connector. Then,
rmlytightenthequickconnectorintotheAirInlet.(See Figure A.)
To Operate The Die Grinder:
1. WARNING! Always wear ANSI approved safety glasses, a full face
shield, and hearing protection when operating the Die Grinder.
2. Use the two Double Ended Spanners (30) provided to loosen the Collet Nut (29).
(See Figure B, next page.)
3. Insert the Collet (28) into the Spindle (25). (See Figure B.)
4. Insert the 1/4” diameter shank of a Grinding Drum (not included) fully into the
Collet(28).Then,rmlyre-tightentheColletNut(29)tolockboththeColletand
Grinding Drum in place. (See Figure B.)
QUICK CONNECTOR (not included)
RECOMMENDED COMPRESSED AIR SYSTEM
AIR INLET (1)
AIR HOSE
(NOT INCLUDED)
QUICK CONNECTOR TO OILER
(NOT INCLUDED)
QUICK COUPLER
(NOT INCLUDED)
OILER
(NOT INCLUDED)
FILTER
(NOT INCLUDED)
REGULATOR
(NOT INCLUDED)
AIR HOSE
(NOT INCLUDED)
COMPRESSOR
(NOT INCLUDED)
FIGURE A
 previous next