Harbor Freight Tools 36572 Grinder User Manual


  Open as PDF
of 10
 
SKU 36572 For technical questions, please call 1-800-444-3353 PAGE 7
GRINDING DRUM
(NOT INCLUDED)
COLLET
(28)
SPANNER
(30)
SPANNER (30)
COLLET NUT
(29)
SPINDLE
(25)
FIGURE B
5. Connect the air supply hose to the quick connector (not included) on the Die
Grinder. Turn on the air compressor, and set its regulator to the recommended
90 PSI for the Die Grinder. (See Figure A.)
6. In order to keep the air supply hose out of the way, hang it over your shoulder.
7. IMPORTANT! GriptheDieGrinderrmlywithboth hands.
8. TriptheSafety(31)withyournger.Thenslowlyapplyhandpressuretothe
Trigger (15) until the desired speed is obtained. NOTE: The Die Grinder always
turns the Grinding Drum clockwise. (See Figure C.)
SAFETY
(31)
TRIGGER
(15)
9. WitharmgripontheDieGrinder,lightlyapplytheGrindingDrumtothe
workpiece, slowly and steadily moving the Grinding Drum to the right and left
untilyouhaveachievedthedesiredappearance(nish)ontheworkpiece.
10. Once the work is completed, release hand pressure on the Trigger (15). The
Safety (31) will automatically return to its locked position to prevent the Trigger
from accidentally being activated. (See Figure C.)
11. Turnofftheaircompressor.TriptheSafety(31)withyournger,andslowly
squeeze the Trigger (15) to release any remaining air pressure from the Die
Grinder. Then, disconnect the air hose from the tool. (See Figure A.)
FIGURE C
 previous next