Filter
Top Products
Page 7SKU 42597
6. Adjust the reciprocating speed of the Saw by moving the Speed Adjust (58) with your
thumb (forward or backward) while the Saw is turned ON.
7. To stop the Saw, release the Trigger Switch (57).
8. Rotate the Variable Switch to return the reciprocating speed to its slowest position.
Warning: If the saw jams, immediately shut off the saw and then remove the saw from
the cutting area. If finished with the cut, shut off the saw and be careful not to
come into contact with the blade.
Maintenance
1. Periodically clean or blow out the motor ventilation slots.
This will prevent the motor from overheating.
2. Replace the saw blade when it becomes worn, bent, or damaged in any other way.
3. Wipe the tool with a clean cloth after every use.
4. Over time, the Carbon Brush (46) in the motor will wear and may need replacement.
When the Carbon Brush is completely worn out, the Saw will not operate. The Carbon
Brush should be replaced by a qualified technician. The Carbon Brush can be
accessed for evaluation or replacement by a qualified technician, by removing the
Brush Holder (44) atop the Left and Right Body (49 and 50).
REV 09/01 REV 04/03