Filter
Top Products
SKU 43477 PAGE 5
PANEL
LIGHT
TIMER
KNOB
8. Lower the Handle completely and hold in place. (NOTE: At this point the Panel
Light (part #45) will illuminate, indicating the Heat Element (part #34) has auto-
matically turned on - see illustration below.)
9. Continue holding the Handle in the downward position. When the desired heating
time expires the Panel Light will automatically shut off, indicating the Heat Element
has automatically shut off.
10. Hold the Handle in the downward position another 1-2 seconds, then lift the Handle
completely in the upward/open position and remove the sealed bag.
11. If desired, you may trim the excess waste bag material at the top edge of the sealed
bag with scissors.
Troubleshooting:
1. If the bead is broken along the sealed edge of the bag, this indicates the length of
heating time is set too long. To shorten the heating time, turn the Timer Knob
counterclockwise.
2. If the edge of the bag does not seal, this indicates the length of heating time is set
too short. To lengthen the heating time turn the Timer Knob clockwise.
43477 manual.p65 10/15/03, 3:19 PM5