Filter
Top Products
Page 4SKU 44141
Note: Performance of this tool (if powered by line voltage) may vary depending on variations
in local line voltage. Extension cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 8 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
Warning:
There are certain applications for which this tool was designed. Harbor Freight Tools
strongly recommends that this tool not be modified and/or used for any application other
than which it was designed.
All accessories must be rated for at least 25,000 RPM. Wheels and other
accessories running over rated speed can fly apart and cause injury.
For safest operation, it is recommended that only these accessories be used with this
product:
Abrasive Cut-Off Discs and Wheels Flap Wheels
Wire Brushes Wire Wheel Brushes
1/4” Shaft Grinding Wheels Rotary Burrs
Always use an approved and proper guard when using the above mentioned
accessories. Each accessory must have the correct arbor size and must fit properly
on the shoulder bushing. Make sure accessories are tightened down securely.
CAUTION: NEVER INSTALL A CARBIDE TIPPED OR STEEL CIRCULAR
SAW BLADE FOR USE ON THIS DIE GRINDER. NEVER INSTALL A
WOOD CARVING BLADE, CARVING DISC WITH SAW CHAIN CUTTERS,
OR A CUTTING CARVING DISC ON THIS DIE GRINDER.
Rev 01c, 08a
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contains chemicals known [to the State of California] to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement or other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to lter
out microscopic particles. (California Health & Safety Code § 25249.5, et seq.)