Filter
Top Products
Page 13For technical questions, please call 1-800-444-3353.SKU 44505
Adjusting the Feed Wheel Return Tension
Spring
CAUTION! Wear an ANSI-approved full
face shield during this procedure.
Move the Chuck to its uppermost 1.
position.
Loosen Hex Nuts (31) and move both to
2.
the lowermost position.
This will keep the Chuck from falling
during this adjustment.
Insert a screwdriver in the lower-front 3.
notch of the Spring Cap (29).
Hold it in place and, using a wrench,
remove the (outer) Hex Nut (30) only.
With the screwdriver still in place, loosen
4.
the (inner) Hex Nut (30) until the Spring
Cap notch disengages from the Spring
Retainer (27) -- about 1/8 inch.
Hex
Nuts
(30)
Spring
Cap
(29)
Notch
Hex
Nuts
(31)
Pointer
(32)
5. Turn the screwdriver counterclockwise
and engage the next Spring Cap notch.
Leave the screwdriver in place.
Tighten the (inner) Hex Nut just enough 6.
to engage the notch.
If this Hex Nut is too tight, it will
restrict (up and down) Chuck-Spindle
movement.
Loosen and screw the Hex Nuts (31) to 7.
the top of the Stop Rod (B12).
Pull the Feed Knob and check the spring
8.
tension, making sure the up movement is
smooth and complete.
From one inch down, the Chuck should
return to its uppermost position. If more
tension is required, repeat steps.
Replace the (outer) Hex Nut and tighten 9.
on top of the (inner) Hex Nut.
Do not overtighten.
If the (up/down) movement is restricted, 10.
slightly loosen the (inner) Hex Nut, and
retighten the (outer) Hex Nut.