Filter
Top Products
Page 6SKU 44716 For technical questions, please call 1-800-444-3353.
AIR CONNECTION
Note: Air Compressor is not supplied.
1. Acquire a Union tting (not supplied) and screw into the Air Inlet tting.
Tighten with the wrench.
2. Attach a quick-coupler (not supplied) to the Union tting if desired. This
allows quick exchange of the Air Hose to other air tools.
3. Connect the Air Hose to the Air Inlet Coupling.
Warning: Follow all air compressor warnings before using tool.
This air tool requires lubrication during operation. For best results, it is recom-
mended to have an oiler and water lter in line with the air supply as shown on
Page 5. This will extend the life of the tool.
AIR COMPRESSOR ASSEMBLY DIAGRAM
OPERATION
Warning: Before installing the attachment, make sure Grinder is not
attached to the air supply and make sure no built up air pressure
remains in the Air Die Grinder.
1. Select the desired grinding attachment.
2. As shown in the diagram on Page 7, use the Wrenches (28) to hold the
Retainer [24] while removing the Collet Nut (27).
3. Insert the shaft of the grinding attachment into the Collet (26).
4. Reassemble the Collet and Collet Nut. Tighten with both Wrenches.
5. Set the Air Compressor’s pressure regulator to 90 PSI.
6. Connect the Die Grinder to the Air Compressor’s hose.
Rev 07i