Page 7SKU 44716 For technical questions, please call 1-800-444-3353.
NOTE: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.
MAINTENANCE
1. If an in-line oiler is not used, disconnect the air hose and apply a few
drops of pneumatic tool oil through the air inlet coupling before each use.
Do this for every hour of continuous use.
2. Apply a few drops of oil to the Lever mechanism and work the Lever a
few times to lubricate.
Note: Do not use detergent, oil or additives; these will cause accelerated
wear to the tool’s air seals.
3. Wipe the Die Grinder clean of oil and grease with a clean cloth.
4. Do not allow the attachments to come in contact with oil or grease.
5. Replace the Die Grinder and attachments to the case and store in a
clean and dry location.
ASSEMBLY DIAGRAM
Rev 07i