Filter
Top Products
Page 3SKU 44849 For technical questions, please call 1-800-444-3353.
CHECK FOR DAMAGED PARTS. 10. Before using this product, carefully check that this tool
will operate properly and perform its intended function. Check for damaged parts and any
other conditions that may affect the operation of this tool. Replace or repair damaged or
worn parts immediately.
REPLACEMENT PARTS AND ACCESSORIES. 11. When servicing, use only identical
replacement parts. Only use accessories intended for use with this product. Approved
accessories are available from Harbor Freight Tools.
MAINTAIN THIS PRODUCT WITH CARE. 12. Keep this tool clean and dry, and keep drill
bits clean and sharp for better and safer performance.
USE THE RIGHT PRODUCT FOR THE RIGHT JOB13. . Do not use a small tool or attach-
ment to do the work of a larger industrial tool. Do not use this product for a purpose for
which it was not intended.
PEOPLE WITH PACEMAKERS SHOULD CONSULT THEIR PHYSICIAN(S) BEFORE 14.
USE. Electromagnetic elds in close proximity to heart pacemaker could cause pace-
maker interference or pacemaker failure.
WARNING: 15. This product contains or, when used, produces a chemical known to the State
of California to cause cancer and birth defects or other reproductive harm.
(California Health & Safety Code § 25249.5, et seq.)
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
TO REDUCE THE RISK OF PERSONAL INJURY WHERE THE DRILL BIT MAY CON-1.
TACT HIDDEN WIRING, hold tool by its plastic insulated gripping surfaces located on the
Left Case (15) and the Right Case (3). Contact with a “live” wire will make exposed metal
parts of the Drill “live” and will shock the operator.
REMOVE ADJUSTING KEYS AND WRENCHES. 2. Make sure all adjusting keys
and wrenches are removed from this product before turning it on.
MAINTAIN A SAFE WORK ENVIRONMENT. 3. Do not expose the Drill, Battery, or Trans-
former to rain or wet conditions. Keep work area well lit. Make sure there is adequate
surrounding work space. Do not operate this product in the presence of ammable liq-
uids, gases, or dust.
DO NOT FORCE THE TOOL. 4. This product will do the work better and safer at the speed
and capacity for which it was designed.
SECURE THE MATERIAL. 5. Whenever possible, use clamps or a vise to hold the material
when drilling.
NEVER USE YOUR BODY TO BRACE THE DRILL. 6. Never put your hands, or other
body parts, between the part of the Drill being braced and the object it is being braced
against.
ALWAYS DISCONNECT TOOL FROM ITS ELECTRICAL SUPPLY SOURCE BEFORE 7.
PERFORMING ANY SERVICES OR MAINTENANCE such as changing drill bits, leaving
REV 07i