Filter
Top Products
Page 2
SKU 44859
Specifications
ITEM DESCRIPTION
Power 110VAC, 60 Hz, 550 watts
Motor 3/4 HP
Distance between Centers 12 inches
Swing over Bed 8 inches
Spindle Step Speeds 125, 210, 420, 620, 1000, 2000 RPM
Spindle Bore 3/4 inch
Spindle Taper MT3
Tailstock Taper MT2
Chuck Capacity 4 inch, 3-jaw; reversing jaws
Cross Slide Travel 4-1/2 inches
Tool Slide Travel 2-3/4 inches
Slide Scale 0.001 inch per mark tool
Metric Thread Pitches 10 (0.4 ~ 3.0 mm)
SAE Thread Pitches 12 (8 ~ 40 TPI)
Accessories - 3 reverse jaws for chuck
- Chuck wrench
- Dead centers MT2 and MT3
- Wrenches: 10-12 open end, 14-17 open end
17-19 open end, 45-52 round nut, tool post
- Hex wrenches: 3, 4, 5, 6mm
- 2 Drive Belts
- Threading gear set
Weight 254 lb.
NOTE: The Splash Guard shown in the cover page photo is not included. It can be
ordered from Harbor Freight Tools using SKU 26962.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
07h, 07l