Filter
Top Products
Page 5
SKU 44859
Installation
1. Carefully place the Lathe on a sturdy, level work table with sufficient light.
2. Use appropriate hardware (not included) in the mounting holes of the lathe base, to
properly secure the lathe. The work table must also be properly mounted to the floor.
3. Before operation, verify that the slide, worktable, and spindle can move, and are not
locked in place.
4. Clean machine with nonflammable solvent and oil the machine according to the
lubrication requirements (see Lubrication section) before running the machine.
Operation
This 8 x 12 inch Lathe is capable of machining metal and nonmetallic stock by cutting,
drilling, and milling. It can cut circular surfaces, both inside and out, cones, mill planes or
grooves, and other cutting functions depending on the tools used. It can also create SAE
and metric threads.
Controls
NOTE: The Splash Guard shown in the photo above is not included. It can be ordered using SKU 26962.
07h
ITEM NAME USAGE ASSY NO.
A Reversing Switch Change rotation direction of the spindle 200
B Master Switch Turn machine power On and Off 200
C Turn Lever Moves saddle transversely 500
D Turn Lever Moves saddle longitudinally 600
E Straight Lever Clamps the square tool rest 400
F Straight Lever Moves the square tool rest carriage longitudinally 400
G Straight Lever Controls apron clasp nut 600
H Straight Lever Controls tailstock sleeve 300
I Turn Lever Moves tailstock sleeve longitudinally 300
A
G
F
E
D
C
B
I
H