Filter
Top Products
Page 11SKU 45338
INSPECTION, MAINTENANCE, AND CLEANING
Caution! Make sure the Power Switch of the Hammer Drill is in its “OFF” position
and that the tool is unplugged from its electrical outlet before performing any inspec-
tion, maintenance, or cleaning procedures.
1. Before each use, inspect the general condition of the Hammer Drill. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs, have the problem corrected before further use. Do not use
damaged equipment.
2. Periodically recheck all nuts, bolts, and screws for tightness.
3. Keep clean by wiping with a clean, damp cloth. Never use caustic agents to clean
plastic parts.
4. Store in a clean and dry location when not in use.
5. Periodically, using a rag and light oil, wipe drill bits and other steel parts of the drill to
keep them from rusting.
6. Periodically blow out the motor air vents of dust and debris using compressed air.
7. Over time, if the performance of the tool diminishes, or it stops working completely, it
may be necessary to replace the motor’s Carbon Brush (21). If the Carbon Brush is
only dirty, it can be cleaned with an ink eraser and replaced again.
Replacing or cleaning Carbon Brushes must be completed by a qualified service
technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
REV 06/04