Filter
Top Products
Assembly
SKU 45794 Page 4
Note: This Dust Collector fits perfectly on Harbor Freight Tool’s Universal Tool
Stand, Sku# 7769. It may fit on other 10” Table Saw or Scroll Saw metal stands.
1. To fit onto tool stand, line up the snaps on the collector bag with base of your
tool stand. Make a mark for each driled hole directly above each snap, all the
way around the stand. If you wish, you can measure the distance between the
snaps and lay out the marks accordingly.
2. Match a drill bit to the end of the snap receptor with the phillips head, to deter-
mine the correct hole size.
Note: Before you drill the holes into the tool stand base, it is recommended that
you drill into a piece of scrap or practice material to test the size of the drill hole.
3. Screw the 12 phillips head screws (attached to the snap receptacles) into the
drilled holes. The philips head end should snug into the inside base of the stand
firmly enough for continual snapping and unsnapping as you empty the bag.
Make sure the snap receptacle end faces outside and the philips end inside.
4. Snap on bag by hand. Never hammer on snaps, they will break.
Operation
1. Before operation check to see that all of the snaps are firmly fastened.
2. Begin operation and work while periodically checking the bag. Do not let the
bag become more than two thirds full. A full bag causes too much stress on the
snaps.
3. Put on goggles and dust mask to empty bag.
Maintenance
1. Check snap receptacles and make sure they are firmly in place.
2. Check bag for tears.
Note: No replacement parts are available for the Dust Collectior System.