Filter
Top Products
Page 3For technical questions, please call 1-800-444-3353.Item 45891
Installation
1. The safe has four concrete fasteners that
are inside of the safe when you open
it. There is also a mounting template
included with the safe. Place the mounting
template against the area you will be
mounting the safe and tape it into place.
WARNING! Before drilling or driving
nails, make sure there are no wires,
cables or pipes in the path.
2. To attach the safe to a wood surface,
hammer a nail (not included) to
mark the hole placement. Drill an
1/8"diameter pilot hole into each
mounting hole location. Place the safe
over the mounting holes and secure
the safe using four 1/4" diameter
self-tapping screws (not included).
3. To use the concrete fasteners, drill a
small pilot hole through the template
to mark the hole placement. Next drill
four holes in the correct location, using
a concrete drill bit. Drill the holes the
same diameter as the fasteners and 2"
deep. Hammer the fastener in the hole
with the flat side going into the hole first.
Use a wood block between the bolt and
the hammer to protect the threads.
4. Place the safe over the bolts (with
the nut removed from the bolts)
and tighten a nut onto each bolt. As
you tighten the nuts onto the bolts,
the fasteners will expand inside the
cement, securing the safe into place.
Operation
1. To Open the Safe: Input the numbers
“159” on the Electronic Key Pad, then
press either the “A” or “B” Key. Once the
Green light is on, turn the Knob and pull
the Door open. Note: The knob must be
turned within 5 seconds of the Green light
coming on. If the knob is not turned, the
entry code will need to be re-entered.
2. To Close: Close the Door and turn
the Knob in the opposite direction.
The Safe is now locked.
3. To Change the Code: The Safe comes
preset with a default code of “159.”
To change the Code, first follow the
instructions for opening the Safe. On
the inside of the Door toward the hinge,
you will see a small Red Button. Press
this Button until the Yellow Light on
the Front Control Panel lights up. Now
you can input the new Code (1 to 8
characters) into the Front Control Panel,
followed by either the “A” or “B” Key.
The Safe will beep twice to confirm that
the Code has been changed. Important:
If the Safe beeps three times, then
the Code has not been accepted, and
you must repeat the steps above.
4. To Change the Batteries: If the Red
Light and the Green Light are both lit
at the same time, it is time to change
the Batteries. Follow the instructions
for opening the Safe. The Battery
Compartment is located on the inside
of the Door. Slide the Battery Cover off
of the Battery Compartment, remove
used Batteries, and insert four new
“AA” Batteries. Once you have changed
the Batteries, be sure to test the Code
before you close the Door again.
REV 02d, 04c, 07b