Filter
Top Products
SKU 47003 PAGE 12
LOCK PIN
(40)
FIGURE F
6. Use the 8mm Hex Wrench (76) to
remove the Screw (60).
NOTE: Make sure to turn the Screw
counterclockwise
to remove.
(See Figure G.)
7. Remove the Small Flange (59).
Then, remove the Outer Flange (58).
(See Figures G and H.)
8. Remove the old Cut-Off Wheel (57),
and replace it with a new Cut-Off
Wheel.
CAUTION! Use a 14” diameter
Cut-Off Wheel with a 1” round Arbor
hole, and rated at a minimum of 4,000
RPM. Cut-Off Wheels that do not
match the mounting hardware of the
Saw or that are rated at less than the
saw’s maximum RPM may fly off the Saw or may run eccentrically, causing loss of
control.
FIGURE G FIGURE H
8 mm
HEX WRENCH
(76)
SCREW
(60)
SCREW
(60)
SMALL
FLANGE
(59)
OUTER
FLANGE
(58)
9. Reinstall the Outer Flange (58) (with the concave side facing the Wheel), Small
Flange (59), and Screw (60). NOTE: Make sure to firmly tighten the Screw in a
clockwise
direction while depressing the Lock Pin (40). (See Figures G and H.)
10. Reinstall the Swing Guard (61), and secure it in place with the Guard Retainer
Screw (62). Make sure to tighten the Screw in the screw hole referred to in
Figure D. (See Figures D and E.)