Filter
Top Products
SKU 47003 PAGE 13
The Quick Lock Vise:
1. The Quick Lock Vise allows for the angle of cut to be adjusted from 0 to 45 de-
grees to the left and 0 to 45 degrees to the right. To adjust the angle of cut,
loosen the two Screws (15). Move the Fixed Clamp (3) to the desired angle as
indicated by the line on the Base (2) of the Cut-Off Saw. Then, retighten the two
Screws. (See Figure I.)
2. The Quick Lock Vise features a Quick Release Lever (11) which allows the op-
erator to quickly release from the Vise the workpiece being cut. To use the Quick
Release Lever, pull the lever rearward to disengage the threads. Slide the clamp
forward until it contacts the workpiece. Lower the release lever, then tighten by
turning the handle clockwise. To remove the workpiece, loosen the Clamping
Screw slightly. Raise the Quick Release Lever and pull back on the Clamping
Screw. (See Figure I.)
FIXED CLAMP (3)
CLAMP
PLATE
(16)
CLAMPING
SCREW
(4)
SCREW
(15)
QUICK RELEASE
LEVER
(11)
SCREW
(44)
FIGURE I
To Adjust The Depth Of Cut:
1. The depth of cut may be adjusted, using the Screw (44).
To cut shallower: Turn the Screw
counterclockwise
. Then, tighten the Hex Nut.
To cut deeper: Loosen the Hex Nut and turn the Screw
clockwise
. Then, tighten
the Hex Nut. (See Figure I.)
To Operate The Cut-Off Saw:
1. To operate the Cut-Off Saw, first make sure the Saw Arm (46) is in its the upright
position with the Swing Lock Handle (81) disengaged. (See Figure D.)
SAW BASE
(2)