Harbor Freight Tools 52847 Grinder User Manual


  Open as PDF
of 6
 
UNPACKING
When unpacking, check to make sure all parts shown on the Parts List and Assembly Diagram
are included. If any parts are missing or broken, please call Harbor Freight Tools at the number
shown on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
ALL PARTS BELOW REFER TO THE PARTS LISTED AND SHOWN IN THIS MANUAL.
To Connect The Air Die Grinder To An Air Hose:
1. The Air Die Grinder requires the attachment of a 1/4” NPT Quick Connector (available from
Harbor Freight Tools). (See Figure A)
2. Wrap the male threads of the Quick Connector with about 3” of Teflon tape. Then, wrench
tighten the Quick Connector into the Air Inlet of the Air Die Grinder.
3. Next, connect the Quick Coupler of an air hose onto the Quick Coupler of the Air Die Grinder.
The Air Die Grinder is now ready for use.
To Insert/Change Collets In The Air Die Grinder:
1. The Air Die Grinder comes with a
1/4” Collet
(part #27). This allows the Air Die Grinder to
accept grinding wheels with a 1/4” shank.
(See Assembly Diagram.)
SKU 52847 PAGE 4
FIGURE A
 previous next