Filter
Top Products
SKU 65410 For technical questions, please call 1-800-444-3353. Page 9
to properly power the tool, but the
output will not exceed the tool’s
maximum air pressure at any time.
Turn the knob clockwise to increase
pressure and counter-clockwise to
decrease pressure. Adjust the pres-
sure gradually, while checking the air
output gauge to set the right pressure
range.
The Air Compressor will cycle up to 10.
115 PSI before shutting off. It will
start to build pressure again when the
PSI of the Compressor drops to 85
PSI.
After the job is complete, move the 11.
Power Switch to the OFF position.
Close the Pressure Valve.12.
Pull down on the Safety Valve under-13.
neath the Gauges to release pres-
sure. Squeeze the Trigger of the air
tool to release pressure from the line
Safety Valve
(51)
Turn the Drain Valve at the bottom 14.
of the Tank two turns to release any
built-up moisture. Close the valve
after moisture has drained out. Do
not remove the Drain Valve.
Drain Valve
Disconnect the air hose and tool.15.
To prevent accidents, disconnect its 16.
power supply after use. Clean, then
store the tool indoors out of children’s
reach.