Filter
Top Products
SKU 65673 For technical questions, please call 1-800-444-3353. Page 10
The Fence has a scale indicating 1.
degrees from 90 to 135.
The Fence can also be set to 0.2.
Functions
Cutting Depth Adjustment
Face the Knob (83) and turn it clock-1.
wise to decrease depth.
To increase cutting depth, turn the 2.
Knob (83) counterclockwise.
DO NOT adjust the cutting depth so 3.
that it exceeds 1/8”.
Push Block
The Push Block (89) has a screw by
which the Push Block can be at-
screw and turn knob until Push Block
is secured in place.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
Replacing Blades
Make certain to check tightness of 1.
the Blade Hex Bolts prior to each
use.
Release Stop Block and remove 2.
Fence.
Use Hex Wrench (not included) to 3.
loosen Hex Bolts and remove worn
Blades (58). Replace with new
Blades.
Set Scale to zero. Using a straight 4.
edge, lay it across Blades. At point
that Blade touches straight edge,
the Blade should evenly touch the
straight edge and be square the
Planer face.
Work Piece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe 2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.