Filter
Top Products
SKU 66222 For technical questions, please call 1-800-444-3353. Page 12
Do not stop your motion when spray-4.
ing the work piece. Stopping will
cause to build up, and run or sag.
Hold the Spray Gun vertically. Hold-5.
ing the gun at an angle will affect the
spray pattern.
Do not spray too heavily. Heavy spray 6.
will cause drips, sags and runs. Build
up the paint surface with several light
coats. Apply each coat when the
previous one is tacky but not yet dry.
This will allow the over coat to adhere
to the previous layer, but will not be
so heavy as to cause sags, runs or
drips.
You must also avoid thick, clumpy 7.
paint surface called “orange peel”.
Prevent orange peel by thinning the
paint properly before spraying. Then
spray successive light, even coats.
Operating the HVLP Sprayer
Cover all items you do not want 1.
painted, using painters plastic or a
drop cloth (not included).
Connect your air supply hose to the 2.
Air Inlet (32).
Adjust the Air Regulator to 15-45 PSI.3.
Fill the Cup (28) with thinned paint. 4.
Remember to pour the paint through
a strainer. Replace the Lid (29) and
screw on tightly.
Put on a ventilator and other safety 5.
equipment recommended in the
Safety Section of this manual.
Point the Sprayer toward the work 6.
material and squeeze the Trigger
(36). Paint will spray.
Move the spray across the work 7.
piece as needed.
When done painting, release the Trig-8.
ger (36). The gun will stop spraying.
The Gun Body (8) has a hook built 9.
into the top for convent hanging dur-
ing pauses in operation.
When done painting, pour remaining 10.
paint from the Cup (28) into an appro-
priate container.
Clean the Sprayer thoroughly be-11.
fore putting it away.
To prevent accidents, turn off the 12.
tool, detach the air supply, safely
discharge any residual air pressure
in the tool, and release the throttle
and/or turn the trigger to its off posi-
tion after use.
Then store the tool indoors in a safe 13.
place out of children’s reach.