Filter
Top Products
SKU 67024 For technical questions, please call 1-800-444-3353. Page 8
are found, do not use tool until
repaired.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn tool off and
remove Battery Pack before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY: Do not adjust or
tamper with any control or
component in a way not
specically explained within
manual. Improper adjustment
can result in tool failure or
other serious hazards.
Charging
Please refer to the Charger manual 1.
for important safety warnings and
proper instructions on charging the
Battery Pack (40).
WARNING! 2. Do NOT use a different
Charger or Battery to power this Drill.
General Operating Instructions
Note:1. When tool is not being used
or when battery, drills, or screwdriver
bits are being attached or removed,
slide Direction Selector (38) to its
mid-position to lock Trigger.
Note:2. To change direction of rotation,
This Drill is designed to accept up to 3.
well as hex shank screwdriver bits
and bit holder adapters. Do not use
gears/motor may result. Always use
Slide Direction Selector (38) to its 4.
mid-position. While holding ring
behind collar of Chuck (2) with one
hand, rotate collar counterclockwise
bit or hex shank of bit/adapter into
Chuck. Turn collar clockwise to hand
tighten (do not use pliers.)
Turn Torque Selector (6) to the de-5.
sired setting and then slide charged
battery pack onto base of tool until
locked into position. Gently pull on
battery to ensure that it is locked
securely. Slide Direction Selector to
right for drilling / fastening or to left
for reversing.
Place one hand over top of housing 6.
for greater tool stability. With other
Trigger to activate motor. Use Cylin-
of the housing as alignment guides.
Do not force bit. Excessive force will 7.
damage tip and lead to tool failure.
If drill bit becomes stuck, immediately 8.
release Trigger allowing tool to come
to complete stop. Slide Direction
Selector to left to its reverse position
9.
when not in use, remove the attach-
ment and the battery pack from the
tool.