Filter
Top Products
SKU 90399 For technical questions, please call 1-800-444-3353. Page 2
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to re-
duce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. THIS TOOL DOES NOT USE A SAFETY MECHANISM; extreme caution must be
used whenever this tool is connected to an air supply. If the tool is dropped or if the
Hammer Face (10) is accidentally struck, then the tool will fire a staple, potentially caus-
ing SEVERE PERSONAL INJURY.
2. Keep work area clean. Cluttered areas invite injuries.
3. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
4. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, extension cords, or air hoses.
5. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
6. Use the right tool for the job. Do not attempt to force a small tool or attachment to do
the work of a larger industrial tool. There are certain applications for which this tool was
designed. It will do the job better and more safely at the rate for which it was intended.
Do not modify this tool and do not use this tool for a purpose for which it was not in-
tended.
Specifications
Note: SKU 90429 - 2”, 15 Gauge Staples are available from Harbor Freight Tools.
Note: This Floor Stapler is designed for use on wood floors.
Air Inlet 1/4” - 18 NPT
Recommended Air Pressure 70-90 PSI
Maximum Air Pressure 100 PSI
Dimensions 22-1/2” x 17-1/2” x 3-1/8”
Weight 21.85 Lbs.
Magazine Capacity 80 Pcs. / Top Loaded
Air Consumption 5.0 CFM @ 80 PSI
Fastener Size Range 3/4” to 2” Long x 15 Gauge
Staples included: 400, 1/2” crown, 2” Long, 15 Gauge
Iincludeds: Tool Oil, 3 Hex Wrenches, Storage Case, Hammer
REV 11/04; 04/05; 02/07