Filter
Top Products
Page 5
SKU 91009
1. You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet
on the Spray Gun. First, wrap the 1/4” air connector (not included) with pipe thread
seal tape before threading it into the Air Inlet (32). Connect the 3/8” ID Air Source Hose
to the Spray Gun.
2. Set the air pressure on your compressor to 40 PSI. Do not exceed the maximum air
pressure of 50 PSI.
3. Check the air connection for leaks and then disconnect the tool from the air source.
For best service you should incorporate a regulator and inline filter, as
shown in the diagram above. Hoses, couplers, regulators, and filters are all
available at Harbor Freight Tools.
Operation
Air Inlet (32)
Lid (29)
Trigger (37)
Fluid Control Knob (12)
Cup (28)
Air Adjusting Valve (31)
Air Nozzle (1)
Vent (30)
Spray Regulator Knob (20)
Sprayer
1/4” NPS