Filter
Top Products
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instruc-
tions, operating and maintenance procedures, parts list and diagram. Keep your invoice with
this manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
1. Keep work area clean. Cluttered areas invite injuries.
2. Keep children away. Children must never be allowed in the work area. Do not let children
be near this product. This product can tip over and cause injury.
3. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving
parts.
4. Use eye protection. Always wear ANSI approved impact safety goggles when using
this product. Use Paint Spraying equipment in well ventilated areas. Wear a face mask
and protective goggles when spraying. Avoid using near flame as most paints are
combustible.
5. Do not overreach. Keep proper footing and balance at all times when using this product.
Be sure this product is level after assembly.
6. Replacement parts. When servicing, use only identical replacement parts. Use of any
other parts will void the warranty.
7. When spray painting always adhere to all the instructions and safety warnings provided
in the painting manual of the spray gun and the paint being used.
8. Avoid sharp edges. Machined edges may cause injury if handled without caution.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
SKU 91603 Page 2
DESCRIPTION
7-3/4” L X 4” W X 14-1/8” H X 20-5/8” Dia.
Alloy Steel Frame
Zinc-Plated Spray Gun Holding Ring
Upper Holder 1-3/16” W X 1-1/2” D
Bottom Holder 1-3/16” W X 1-1/8” D
ITEM
Overall Dimensions
Construction
Gun Holder Dimensions
Specifications
The Spray Gun Holder holds most cup style gravity feed spray guns. Included is a
removable strainer holder to make refilling the spray cup faster and easier.
For technical questions, please call 1-800-444-3353.