Harbor Freight Tools 91603 Paint Sprayer User Manual


  Open as PDF
of 4
 
SKU 91603 Page 3
.
Maintenance
1. Keep indoors to avoid rust.
2. Wipe surfaces with a damp cloth or paint thinner, depending on what type paint was
used. Rinse off and dry thoroughly. Use Caution: Paint thinner is flammable and must be
disposed of and stored properly.
For technical questions, please call 1-800-444-3353.
Figures 1 Figures 2
Ring Holder (3)
Steel Rod (4)
Holding
Bracket (6)
Base (7)
Washer (2)
Bolt (5)
Holding
Bracket (6)
Unpacking
When unpacking, check to make sure the following parts are included that are listed
on Page 4. If any parts are missing or broken, please call Harbor Freight Tools at the
number on the cover of this manual.
Assembly and Usage Instructions
The Gravity Spray Gun Holder holds most cup style GRAVITY FEED spray guns.
1. At one end of the Steel Rod (4), attach Ring Holder (3) using a Washer (2) on
each side of the Ring Holder and Tighten with Nut (1). This Ring Holder is used
to hold a strainer (not included) as an aid when filling the spray gun cup with
paint.
2. Attach the other end of the Steel Rod (4) through the Holding Bracket (6) using
Washers (2) and Nuts (1). Attach Base (7) to the Holding Bracket (6) using
Bolts (5), Washers (2), and Nuts (1).
See Figures 1 and 2.
3. Your spray gun will rest on the Holding Bracket (6) as needed. Be careful not
to tip or bump the holder as it may fall.
IMPORTANT:
Refer to the manual of the paint spray gun and paint you will use
for necessary warnings and instructions before use.
 previous