Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 91773
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn off the tool, detach the air
supply, safely discharge any
residual air pressure in the tool,
and release the Trigger before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with
any control or component in a
way not specically explained
within this manual. Improper
adjustment can result in tool
failure or other serious hazards.
Installing Sandpaper
2-3/4” x 17-1/2” strips of sandpaper (sold
separately, Item # 5263) are used with
this Inline Sander. The sandpaper is held
in place at each end of the Sander with
toothed clamps and a tension bar.
Figure 2
Tension bar
Clamp
Clamp
Tension bar
To Install the sandpaper:
Figure 3
Raise
Tension bar
1. Pull up on the tension bar at each end of
the Sander.
Figure 4
Sandpaper
Screwdriver
Teeth
Lower
Tension bar
2. Center the Sander over the back side
of the sandpaper. Slide one end of the
Sandpaper under the teeth. Hold in place
with a screwdriver (sold separately) and
lower the tension bar to secure the end.
Check that the sandpaper is aligned 3.
along the length of the sanding pad and
slide the sandpaper under the teeth at
the other end of the Sander, pushing
the Sander towards the clamped end to
REV 10f