Filter
Top Products
SKU 92359 For technical questions, please call 1-800-444-3353. PAGE 7
Loading Coil Nails
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN
RELOADING OR DOING ANY OTHER MAINTENANCE ON THIS TOOL.
Other people in the work area must also wear ANSI approved impact safety
goggles.
Warning! Make sure the Nailer is not attached to the air hose whenever loading
the tool.
NOSE
TRIGGER (47)
AIR INLET (93)
5. Connect the air supply to the tool at the Air Inlet (93). Set the regulator at the
recommended 65 PSI to 120 PSI, and set not to go over the maximum 120 PSI.
6. Test the tool by depressing the nose against the workpiece without pulling the
Trigger (47). The Tool must not cycle (fire). If it cycles (fires), stop immediately
and have it repaired by a qualified service technician.
7. Hold the tool away or off of the workpiece. The nose of the tool should return to
its original position. Squeeze the Trigger (47). The tool should not cycle (fire).
If the tool fires, stop immediately and have it repaired by a qualified service tech-
nician.
8. Depress the nose against the workpiece and squeeze the Trigger (47). The tool
must cycle (fire) only once. Release the Trigger and squeeze it again. The
tool must not cycle (fire). With the Trigger held, carefully lift the nailer and
press it against the workpiece again. The tool must not cycle (fire). If it fails to
perform in the manner explained in bold, have it repaired by a qualified service
technician.