Filter
Top Products
SKU 92359 For technical questions, please call 1-800-444-3353. PAGE 9
BOTTOM
VIEW
SCREW
(80)
BRACKET
(79)
SHINGLE SPACING
Operating the Nailer
1. Attach the Nailer to the air supply at the Air Inlet (93). Start your compressor and
check the pressure making sure it is set at the recommended 65-120 PSI and not
to go over the maximum 120 PSI.
2. To fire, place the nose of the Nailer on the workpiece. The Nailer should not fire if
the nose is not depressed. Once depressed, gently and briefly squeeze the
To Adjust The Shingle Gauge:
The Bracket (79) controls roof shingle spacing. To adjust the Bracket to work with
a particular width of shingles, use the accessory Hex Wrench to loosen the Screw
(80) on the Bracket. Slide the Bracket forward or backward to the desired spac-
ing. Then, retighten the Screw.
3. Place a coil of Nails (not included) around the Adjuster Plate (86) in the Nail
Cannister (82).
4. Uncoil enough nails to reach the Feed Hook (50). Place the
second
nail on the
coil between the teeth of the Feed Pawl, making sure the nail head fits in the slot
in the upper portion of the Feed Pawl.
5. Swing the Cannister Cover (89) closed. Then, close the Latch (64). Make sure
the Latch closes securely. If it does not engage, the nail head is not in the slot in
the upper portion of the Feed Hook (50).