Filter
Top Products
SKU 93088 For technical questions, please call 1-800-444-3353. Page 2
SPECIFICATIONS
Air Requirements 3 CFM
Collet ¼”
Maximum RPM 20,000
Working Air Pressure 90 PSI
SAVE THIS MANUAL
You will need the manual for the safety warnings and cautions, assembly instructions, operating
procedures, maintenance procedures, trouble shooting, parts list, and diagram. Keep your invoice
with this manual. Write the invoice number on the inside of the front cover. Keep both this manual
and your invoice in a safe, dry place for future reference.
SAFETY WARNING & CAUTIONS
WARNING: When using pneumatic equipment, basic safety precautions should always be
followed to reduce the risk of personal injury and hazards due to over pressurization.
READ ALL INSTRUCTIONS BEFORE USING THIS TOOL!
KEEP WORK AREA CLEAN.1. Cluttered areas invite injuries.
OBSERVE WORK AREA CONDITIONS.2. Do not use tools in damp, wet, or poorly lit lo-
cations. Don’t expose to rain. Keep work area well lit. Do not use electrically powered air
compressors in the presence of flammable gases or liquids.
KEEP CHILDREN AWAY. 3. Children must never be allowed in the work area. Do not let
them handle machines, tools, or hoses.
STORE IDLE EQUIPMENT. 4. When not in use, tools must be locked up in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
DO NOT FORCE THE TOOL.5. It will do the job better and more safely at the rate for
which it was intended. Do not use inappropriate attachments in an attempt to exceed the
tool’s capacities.
USE THE RIGHT TOOL FOR THE JOB. 6. Do not attempt to force a small tool or attach-
ment to do the work of a larger industrial tool. Do not use a tool for a purpose for which it
was not intended.
DRESS PROPERLY.7. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Nonskid footwear is recommended. Wear restrictive hair covering to con-
tain long hair.
USE EYE AND EAR PROTECTION.8. Always wear ANSI approved chemical splash gog-
gles when working with chemicals. Always wear ANSI approved impact safety goggles
at other times. Wear a full face shield if you are producing metal lings or wood chips.
Wear an ANSI approved dust mask or respirator when working around metal, wood, and
chemical dusts and mists.
REV 07k